Skip to content
A Century of Excellence
Search for:
Menu
Home
SMP Courses
Registration
Login
Powertrain Electronics Assessment
Auto-advance lessons
Click Here For Assessment Quiz
Please sign up for the
course
before taking this quiz.
1.
Technician A states that the voltage PID for a sensor that uses a pullup circuit should go high if the sensor is unplugged. Technician B says the voltage PID for a sensor that uses a pullup circuit should go low if the sensor is unplugged. Who is correct?
Technician A
Technician B
Both Technicians
Neither technician
2.
A technician suspects that a 3-wire sensor has a wiring or module problem and finds the following. What is the most likely fault?
Powertrain 3 wire sensor
The module GND circuit has failed
The module is using a pull-down circuit
The module has failed
The signal wire is shorted to voltage
3.
The illustration below shows a circuit being tested for what?
Powertrain Circuit Testing
Frequency
Current
Voltage
Resistance
4.
A Variable Reluctance sensor can be tested for what two values with a DMM?
Voltage and Amperes
Voltage and Resistance
Duty Cycle and Resistance
Amperes and Frequency
5.
Technician A states that a voltage divider circuit can be used to represent information. Technician B states that a voltage divider circuit is often used as a high-side driver. Who is correct?
Technician A
Technician B
Both technicians
Neither technician
6.
A PCM high side driver:
Handles ground side circuit control to a device
Makes fused circuit protection obsolete
Handles power side circuit control to a device
Is only used for control of high current devices
7.
In this simple circuit, the voltage drop across the bulb is very high but does not equal the total voltage rise. What does this indicate?
Powertrain Simple Cicuit
The bulb will likely illuminate normally
Very high current flow
Excessive resistance
Excessive capacitance
8.
A technician is testing a driver circuit as shown. What should the meter read with a good module?
Powertrain driver circuit
6 volts
12 volts
Battery voltage
0 volts
9.
All these are factors that affect the resistance of an electrical conductor EXCEPT:
Weight
Cross-sectional area
Temperature
Length
10.
Technician A states that if a 5V REF signal to a sensor is shorted to ground, the ECU will be damaged. Technician B states that the module may need reprogramming if this happens. Who is correct?
Technician A
Technician B
Both technicians
Neither technician
Back to:
Click Here For Assessment